Im modifying the intake on my car and i need to drill a few holes into plastic and all my powertools are at home in texas. So can i borrow or use someones drill or drill press?

If you're clever, the BE building and the ME dept. have some.

Well, more nice than clever. I'm not sure if they'll let you use it but if you buy em lunch or something I bet the guys in the ME shop would do the job for you. They shouldn't be too busy, it's not near the end of the semester yet.

LOL, im waay to cheap to buy em lunch to drill 5 holes thru plastic. I could buy some POS drill for that much.

So i go to the ME building and then do what?

You could always see if you have a friend that can sneak you into one of the student design shops.

Go to the basement of the BE building and if anyone asks say you are in BE20.

I've got a drill you can use and any size drill bit imaginable up to 1/2". PM me if interested.

I just used epoxy, seems to be holding so far.

TJ has some you can check out I think.
Just don't tell them you are not a TJ res... if you aren't.

I had to drill two little holes on my wastegate flange for my turbo. I took it to the ME shop and the guy did it righ there in front of me. My stuff was metal too so I'm sure he'll easily do plastic.

BTW have you done this yet?

Yea i already did it, i just used epoxy